Showing posts with label Magnetism. Show all posts
MAGNETIC MOTION
Terrific demonstration of magnetization using ring magnet.
Material required: Plastic bottle, Sticks, Cycle spoke, Steel wire and a
Ring magnet, etc…
Description: Fix
four long wooden sticks to an old plastic bottle. Make a propeller with 12-petals from another bottle and fix
a cycle spoke to its lid. Place a ring-magnet in the spoke. Stand the spoke
upright in two holes on the 4-legged bottle. Place the bottle under a ceiling
fan. The breeze will make the propeller spin. This will rotate the cycle spoke.
The lower end of the spoke would be magnetized because of the ring magnet. If
you keep a steel wire shaped star it will slowly dance with the spinning spoke.
One can also try different shape steel-snake, safety pin or a sewing machine
bobbin.
Different Models:

Tag :
Magnetism,
Eddy Current Levitating Coil
A simple demonstration of eddy-current magnetic levitation using a small copper coil energized with variac and levitated over a large copper plate.

Materials required: 200 turn coil, Variac (AC power), Large copper plate etc.
Description: A 200 turn coil is connected to a variac (AC power) and placed on a large copper plate. When power is applied eddy currents are generated in the plate and the coil levitates.
Note: Do not leave the power on for more than 15 seconds. Coil will get hot. Do not go above 40 on the variac.
Different Models:

Tag :
Electricity,
Magnetism,
Solar pendulum
Solar pendulum is electromagnetically assisted pendulum also known as magbot pendulum

Material required: Neodymium magnet, LED, Coil, Solar cells, Electrolytic capacitors (3300uF and 1000uF), transistors (2N3904 and 2N3906), resistors (100kΩ), diode (1N914), Copper wire, etc.
Circuit diagram: Built the circuit as shown in figure below
Description: Solar cell provide the sufficient DC voltage to the circuit. The Force-Coil circuit uses the motion of the swinging magnet over the coil.
Different Models:
Simple Buzzer
Basic working principle of simple buzzer is electromagnetism.
Material required:
Copper wire (insulated and bare Ended), insulated wire for connection, low-voltage
Power supply or Battery, Hacksaw blade or metal strip, nail or screw
Description: Wind the copper wire around
the nail or screw (about 150 – 200 turns) fixed on base. This will form an
electromagnet. Fix the Hacksaw blade or metal strip on base in such a that the other
end of the blade will remain 2-3 mm above the nail or screw. Connect one end
of electromagnet wire with battery. Connect the other terminal of battery with
fixed end of blade. Another end of electromagnet wire is connected in such a way that it touches the top of the
blade. In this way buzzer sound is produced.
Different Models:


Jacob's ladder a traveling arc generator
A Jacob's Ladder is the type of high voltage "Traveling arc" display
Material required : High Voltage Transformer, Pair of rods (Electrodes), Insulators to mount electrodes etc.
Description: Take two Electrodes and mount them vertically in a slight "V" shape, with the narrow part at the bottom. Connect each wire to a High Voltage Transformer.
The voltage is high enough to form an arc, completing the circuit. Through convection, the arc rises up the long wires, maintaining a connection. When the connection breaks, another arc is formed at the bottom to repeat the cycle.
The voltage is high enough to form an arc, completing the circuit. Through convection, the arc rises up the long wires, maintaining a connection. When the connection breaks, another arc is formed at the bottom to repeat the cycle.
Notes : A traveling-arc device is very dangerous. The transformer at the base of this apparatus generates High voltage.
Different Models:

Tag :
Electricity,
Magnetism,



